Supplies

This cleaning pick is for the removal of dried ink and residue from capping station hard surfaces and wiper blade track on your DTG Printer.

This cleaning pick is for the removal of dried ink and residue from capping station hard surfaces and wiper blade track on your DTG Printer.

This funnel is to fill your DTG ink cartridges.

This Mask/Respirator is perfect for protecting you from the fine mist that occurs when pre-treating garments for DTG printing. They remove at least 95% of solid particles (including ultra-fine mists and microorganisms) from the air you breathe under worst case test scenarios, and are highly recommended for filtering the fine mist produced by pretreatment sprayers. The masks are made of polypropylene with an inner layer of polyester. The adjustable aluminum strip is easily molded to the bridge...

Spigot for Image Armor 5 Gallon Pretreatment box.

DTG Black 2400 Ink Chip for DTG HM1 Garment Printers. Ink Chips are designed for the HM1-Kiosk and the D1/D2-Eclipse printers. Re-settable up to 400ml in 18-20ml increments giving the user much longer run times than the standard cartridge chips would allow.

DTG Cyan 2400 Ink Chip for DTG HM1 Garment Printers. Ink Chips are designed for the HM1-Kiosk and the D1/D2-Eclipse printers. Re-settable up to 400ml in 18-20ml increments giving the user much longer run times than the standard cartridge chips would allow.

DTG Magenta 2400 Ink Chip for DTG HM1 Garment Printers. Ink Chips are designed for the HM1-Kiosk and the D1/D2-Eclipse printers. Re-settable up to 400ml in 18-20ml increments giving the user much longer run times than the standard cartridge chips would allow.

DTG White 2400 Ink Chip for DTG HM1 Garment Printers. Ink Chips are designed for the HM1-Kiosk and the D1/D2-Eclipse printers. Re-settable up to 400ml in 18-20ml increments giving the user much longer run times than the standard cartridge chips would allow.

DTG Yellow 2400 Ink Chip for DTG HM1 Garment Printers. Ink Chips are designed for the HM1-Kiosk and the D1/D2-Eclipse printers. Re-settable up to 400ml in 18-20ml increments giving the user much longer run times than the standard cartridge chips would allow.

The white ink strainer is used when refilling the ink compartment on DTG printers. This is for white ink only.

Poly pump spray bottle used for the spraying of pretreatment onto garments before applying white ink during  Direct to Garment (DTG) printing.

Replacement Waste Ink Pads (Set of 2). These replacement ink pads are made specifically for the DTG Kiosk. Do not use for DTG HM1.

Large syringe for cleaning and maintenance of your DTG Printer. Please refer to your documentation for specific instructions.

Kraft paper is perfect for giving a smooth matte finish when heat pressing DTG prints. Great for heat transfers too! One sheet of Kraft paper is good for up to 75 presses (or when the sheet becomes brittle). This item has special shipping requirements to prevent crushing the paper. If ordering multiple quantities, please call for a shipping charge adjustment.

These foam swabs are perfect for cleaning hard to reach places in DTG printers. The polyurethane foam is highly absorbant yet firm enough to effectively clean hard to reach areas and delicate parts on DTG printers such as print heads and wipers. Safe for use with DTG cleaning solutions. Sold as individual swabs.